====== Manipulation des réglages caméra sous DAVID ======

----
====== MANUEL EN COURS DE TRADUCTION !!! Soyez patients !!! ====== 
----

===== Description =====
In DAVID, you need to adjust camera settings (exposure, brightness, gain, ...) manually. However, DAVID can read and remember those settings for three different situations:
  * Camera calibration
  * Scanning
  * Texture grabbing
DAVID has three buttons that lead you to the camera settings. DAVID remembers those settings three times (separately for the three "situations") and sends them back to the camera when you e.g. move between the calibration and scanning page or when you switch between scanning and texture grabbing.

===== Switching this feature on/off =====
This feature depends very much on the camera drivers. If this feature makes problems with your hardware, you can switch it off:
After you select a camera, DAVID askes you whether you want to allow this or not. \\ 
To switch this feature on or off, just select a different camera (e.g. Video Grabber), then select your camera, and you can choose "Yes" or "No" again.

===== Cameras =====
The following lists are supposed to contain information about different camera models, driver versions, and how well DAVIDs camera parameter management works with them.

=== Working perfectly ===

=== Working acceptably ===
==Logitech Quickcam Pro9000, driver version 11.5 ==
  * Some exposure settings can be restored only approximately
  * Avoid exposure setting 1/1000 s
  * No real problem in practice

=== Not working properly ===


Please share experiences with //your// camera here!